欢迎光临mg4355线路检测官网为您提供:光纤激光切割机,木工加工中心,保丽龙加工中心
收藏mg娱乐娱城官网4355在线留言进入手机站Chinese|English

mg娱乐娱城官网4355,济南木工加工中心,保丽龙加工中心
INFORMATION
业内资讯
联系大家

0531-87229973

朱经理:15020002224
朱经理:15020002224
地址:山东济南市长清区文昌街道办事处郭庄南200米

业内资讯 当前位置:mg娱乐娱城官网4355 - 资讯中心 > 业内资讯 >

木工雕刻机加工时下刀深度不均匀问题解决!

来源: 时间:2020-03-20 

  很多工厂木工雕刻机加工的时候,工艺深浅是根据提前做好图设计好的。比如说下刀要0.5cm,实际的雕刻深度就是0.5。但出现问题的时候,发现该0.5的时候有的地方是0.2,有的地方甚至到1了。这就让人很头疼。
  In many factories, when woodworking and carving machines are used, the depth of the process is designed according to the drawings in advance. For example, it takes 0.5cm for cutting, and the actual carving depth is 0.5. But when there are problems, it is found that some places are 0.2 when it is 0.5, and some places even reach 1. It's a headache.
  发现问题,要解决问题的话,要先了解到哪里出现了问题。一般出现木工雕刻机雕刻不均匀的情况,一般就是以下几个方面除了问题:
  To find and solve problems, we need to know where they are. In general, the uneven carving of woodworking engraving machine is caused by the following problems:
  1.控制卡松动或故障
  1. The control card is loose or faulty
  2.步近电机故障
  2. Step motor failure
  3.驱动器故障或电流细分与App设置不一致
  3. Driver fault or current subdivision inconsistent with software settings
济南木工加工
  4.z轴马达线故障
  4. Z-axis motor line fault
  5.主轴电机故障
  5. Spindle motor failure
  6.变频器干扰或数据设置有误
  6. Converter interference or data setting error
  7.静电干扰
  7. Electrostatic interference
  8.电脑病毒或系统问题
  8. Computer virus or system problem
  木工雕刻机出现这种故障,更好的解决方式是排查。根据实际情况排出掉大部分,然后一一检查。当然,先驱动器,电机,变频器等出现的问题呢,更好还是找厂家解决一下比较好。
  The best way to solve this problem is to check. Discharge most of them according to the actual situation, and then check them one by one. Of course, the first driver, motor, inverter and other problems, it is better to find manufacturers to solve it.
XML 地图 | Sitemap 地图